Isciviti alla newsletter
Sezioni
- Shipping (5655)
- Economia (5053)
- Logistica e Trasporti (4469)
- Infrastrutture (3517)
- Nautica (1498)
- Eventi e turismo (952)
- Cultura (201)
- Diritto - Fisco (100)
- Editoriale (15)
Archivio blog
- ► 2023 (2311)
- ► 2022 (1425)
- ► 2021 (1236)
- ► 2020 (1389)
- ► 2019 (1517)
- ► 2018 (1670)
- ► 2017 (1497)
- ► 2016 (2092)
-
▼
2015
(3095)
-
▼
dicembre
(209)
-
▼
dic 17
(9)
- Concessione di 60 anni per il Terminal Container d...
- Da ABB quadri UniSec per i gelati Nestlè
- Ministers agree on fishing catch limits for 2016
- In Italia solo i "piccoli giganti"?
- Fercam: un programma di investimenti di 50 milioni...
- Interporto Sud Europa hub ferroviario della Polonia
- Treatment standards needed for oily galley water
- USCG’s firm stance on ballast water puts Optimarin...
- WSS primed for Asian growth through new Busan hub
-
▼
dic 17
(9)
-
▼
dicembre
(209)
- ► 2014 (3037)
Treatment standards needed for oily galley water
17 Dicembre 2015 - Marine regulators have been urged to introduce performance standards for the separation of fats from galley water before the oily mix enters the onboard treatment process andcauses system failure. Currently there are no IMO standards for the separation of fats, oils and grease from galley water, despite the treated water having to comply with the MEPC 227(64) regulation, which does not allow the discharge of any oils.
Mark Beavis, the Managing Director of water treatment specialist ACO Marine, said: “Galley water should be free of waste sludge, fats, oils and greases before it enters the treatment process otherwise biological overloading and system blockages can occur, causing system failure and possible pollution. “Although there are standards in place for the discharge of treated sewage and bilge water, the industry should develop treatment standards for galley water which would, in the long term, prevent oily galley water being discharged directly overboard or bypassing the treatment system altogether.”
Until performance standards are in place, Beavis said grease separator manufacturers and operators need to take the environmental initiative themselves. “Manufacturers should as a minimum look to match, or exceed, the land-based regulations for grease separator performance covered in the DIN V4040-2/99 and rated at EN1825, or better the EN1825+, which define the limits for lipoid content of any discharge from the separator. Earlier pre-conceived notions that simple grease traps were sufficient have been proven incorrect; they do not take into account neutrally buoyant substances or more dense solids which can spill over into the discharge side of the unit.”
- Blog Comments
- Facebook Comments
Translate
I più cliccati degli ultimi 30 giorni
-
7 maggio 2024 - In molti ricorderemo questa giornata come una che ha lasciato il segno nella vita economica dello scalo genovese. Di questo ...
-
13 maggio 2024 - Nairobi, in Kenya, è stata designata come la sede della prestigiosa 12ª edizione dell'Africa Fintech Summit (AFTS), in ...
-
13 maggio 2024 – In 10 anni sono scomparse 21.248 aziende di autotrasporto. Dal 2013 al 2023 il totale delle imprese, secondo i dati di Unio...
-
11 maggio 2024 – Addetti all’accoglienza, consulenti di vendita crociere e tecnici luci, suono e video: sono le nuove figure professionali r...
-
13 maggio 2024 – Un evento di portata significativa si è recentemente svolto a bordo della nave Cavour: il convegno "Immersi nel Polo N...
-
13 maggio 2024 - L'Associazione degli Ingegneri Periti di Avarie Marittime ha organizzato il convegno: SINISTRI MARITTIMI COMPLESSI. LA ...